Skydio Enterprise Controller enables access to the advanced autonomy systems allowing operation of Skydio 2/2+ with minimal cognitive effort. The controller needs to be paired with Skydio pre-flight and can only be paired with one drone at a time.

Quick Steps

To pair Skydio Enterprise Controller with Skydio 2/2+:

Step 1 - Power on Skydio Enterprise Controller  
Step 2 - Power on your drone  
Step 3 - Connect the controller to your drone using the USB-C cable CS_S2P_C78_media_illo_connected.png
Step 4 - Wait approximately 15 seconds  
Step 5 - A message will display alerting you to pair the controller CS_C78_media_UI_pair1_S2P.png

Step 6 - The drone name will be listed under DEVICES

paired_drone_select_X2.png
CS_Note_callout-icon.jpg

Pairing only needs to be completed one time.

 

To unpair Enterprise Controller:

Step 1 - Turn off your paired drone CS_C78_media_UI_unpair1_S2P.png
Step 2 - Navigate to the INFO tab and select your drone name under DEVICES  paired_drone_select_X2.png
Step 4 - Select Forget  CS_C78_media_UI_unpair3_anno_S2P.png
Step 5 - Select FORGET to confirm unpairing CS_C78_media_UI_unpair4_cropped.png

Explore More

How to activate your Skydio Enterprise Controller

How to charge your Skydio Enterprise Controller

 

If you have questions or need additional support—feel free to reach out! Skydio Support

 

 

 © 2021 Skydio, Inc. All rights reserved A0181

Was this article helpful?