How to replace sensor package isolators

Published: Updated:

  1. Skydio
  2. Skydio X10
  3. Maintenance and Troubleshooting Skydio X10

To ensure your Skydio X10 system stays healthy, we recommend inspecting the Sensor Package Isolators every 40 flights (or every 30 hours of flight time).

  • If you are storing the drone in hot temperatures (122°F/50°C - 131°F/55°C), then we recommend inspecting every 20 flights (or every 15 hours of flight time)

The Sensor Package Isolators help stabilize the cameras and provide a smooth, crisp image, even in tough flight conditions.

CS_X10_media_UI_replace_isolator2.png CS_X10_media_UI_replace_isolator3.png

Inspect the isolators regularly for any signs of damage. If you notice damage, replace the isolator.

  • Abnormal wear
  • Tears
  • Any separation on the isolator, especially where the inner gaskets meet the main connector

CS_X10_media_UI_replace_isolator1.png

Removing an isolator

Step 1 - Power off and remove the Sensor Package Lock

Leave the sensor package attached.

 STEP_1_RemoveSensorIsolators_PowerOffAndRemoveSensorPackageLock.gif

Step 2 - Remove the isolator from the upper bracket

Gently pull the top part of the isolator down through the upper bracket.

When pulling down, pinch the edges of the inner gasket to give you more leverage and avoid causing a tear.

Use your other hand to help push through the top part of the isolator down through the hole if needed.

 STEP_2_RemoveSensorIsolators_RemoveTheIsolatorFromTheUpperBracket.gif

Step 3 - Remove the isolator from the bottom bracket

You can slightly offset the bracket to give you more working space.

Pinch the edges of the inner gasket, this time pulling up. It helps if you use a slight peeling motion as well.

 STEP_3_RemoveSensorIsolators_RemoveTheIsolatorFromTheBottomrBracket.gif

Installing an isolator

Step 1 - Insert the isolator into the bottom bracket

One side of the isolator will have a hole in it. This end goes on the lower bracket.
Start in between the upper and lower brackets. Thread the edge of the circular piece through the hole in the lower bracket, then pull the rest through from the bottom until fully seated.

Roll and pull the edges down if needed to ensure the isolator is fully seated.

 STEP_1_InstallSensorIsolators_InsertTheIsolatorIntoTheBottomBracket.gif

Step 2 - Insert the isolator into the upper bracket

Thread the remaining half of the isolator through the hole in the upper bracket.

  • You may have to gently align the upper bracket with the hole, as it is designed to be slightly offset

Once you thread an edge through, pinch and pull until the isolator is fully seated.

Check the edges and roll into place if necessary. Once finished, it should match the other isolators on the drone.

 STEP_2_InstallSensorIsolators_InsertTheIsolatorIntoTheUpperBracket.gif

 

Skydio Inc., A0546

Was this article helpful?