Overview

Mid-flight events let remote pilots inject events into a simulated flight in real time to test how the system and pilot respond.

To get started, create a Paraverse simulator: How to Use Skydio Paraverse Flight Simulator.

Supported Mid-flight Events

The following Mid-flight Events can be configured for active simulators:

  • Markers: Generate markers around the drone’s current location to practice responding to an incident marker.
  • Wind: Apply wind for a specified duration to observe how the vehicle holds position and navigates in challenging conditions.
  • Temperature: Change the ambient temperature in the simulator.
  • Battery: Set the vehicle’s simulated battery percentage. Lower the charge to demonstrate low-battery warnings and autonomous return behavior, or increase it to recover a vehicle without restarting the simulator.
  • Connectivity: Introduce receive and transmit packet loss to simulate a degraded or interrupted connection. This can demonstrate video degradation, connection warnings, and autonomous lost-link behavior.

Configure Mid-flight Events

There are two ways to access Mid-Flight Events from DFR Command:

  • Navigate to Settings > Simulator > Mid-Flight Events — Trigger events for all online simulators from a single dashboard. Only currently online vehicles appear. This view is useful when managing multiple simulators at once.
  • Navigate to Fleet > Devices > Simulator Tools — Trigger events for a single online vehicle/simulator.

[note]Because Mid-flight events can only be accessed outside of Remote Flight Deck, Skydio recommends having a second device or tab open in DFR Command to configure changes while actively piloting.[/note]

Was this article helpful?