How to enable 3D Scan Flight Mode

Published: Updated:

  1. Skydio
  2. Skydio 3D Scan
  3. Getting Started 3D Scan

To initiate a scan, you need to change the Flight Mode from Skills to 3D Scan. Your selection will persist through flights and power cycles.

Quick Steps

Step 1 - Power on your drone and controller  
Step 2 - Select the gray button that says Switch Mode CS_3DS_X2_media_UI_switch-mode1.png

Step 3 - Select 3D Scan and reboot

Skydio will automatically restart and reconnect to the Controller and Enterprise App.

 CS_3DS_X2_media_UI_switch-mode2.png

Step 4 - Ready to begin scan setup

After Skydio has finished entering 3D Scan mode, you are ready to fly.

Ensure your Logs Card has been formatted before starting a scan.

Visit the 3D Scan Quick Start Guide for instructions

  

Explore More

Explore related articles for additional information:

3D Scan Quick Start Guide

How to use 3D Capture with 3D Scan

How to use 2D Capture with 3D Scan

 

 Skydio, Inc. A0088

Was this article helpful?